Drying a structure correctly isn't about running a few fans and hoping — it's a calculated process based on temperature, humidity, and airflow readings.
We calculate air mover and dehumidifier placement using psychrometric formulas, not a flat per-room equipment count.
Every Structural Drying And Dehumidification job in Bloomington, MN starts with psychrometric calculations that determine exactly how much airflow and dehumidification capacity is needed.
Low Grain Refrigerant dehumidifiers pull significantly more moisture from the air than consumer-grade units.
Thermal imaging cameras reveal moisture patterns behind walls and under flooring that aren't visible to the eye.
You receive documented daily readings showing the structure actually getting drier.
Below is the calculated, documented process our Bloomington, MN teams follow.
We calculate temperature, humidity, and grain depression readings to build the drying plan.
We map the full extent of moisture intrusion before placing a single air mover.
We position air movers to create directed airflow across wet surfaces based on the assessment.
Daily monitoring confirms equipment is working and adjusts the plan if progress stalls.
Hardwood floors and built-in cabinetry require slower, more controlled drying to avoid warping.
Final verification compares closing readings against the material-specific dry standard, not a general guess.
We ask enough to bring the right instruments on the first visit.
Our nearest Bloomington, MN crew brings diagnostic equipment loaded from the start.
We complete the psychrometric assessment and thermal scan, then provide a written drying plan and quote.
The job closes only once documented readings confirm the structure is fully dry.
"The thermal imaging found moisture behind a wall that looked completely fine from the outside. Would have missed it otherwise." — Julian R.
"They came back every single day to take readings and showed me the numbers improving. Felt like real science, not guesswork." — Monique T.
"Our hardwood floor didn't warp because they slowed the drying process down specifically for it." — Grant P.
A room can look dry on the surface while moisture meters still detect trapped moisture inside materials.
It's a calculated approach using temperature and humidity data to determine exact equipment needs, rather than guessing.
Most jobs run 3-5 days, though hardwood and cabinetry may need longer, more controlled drying.
You'll see the actual numbers improve each day through documented logs.
Yes, we use slower, controlled drying specifically calibrated for hardwood to prevent warping.
We treat flat readings as a signal to recalculate, not something to wait out.
If your property is in or near Bloomington, a crew can typically respond the same day.
Speak directly with our structural drying team.
Call +1-844-833-1325